Myford MG12 HPT Automatic Cylindrical Grinder

MAXIMUM GRINDING DIAMETER .......................... 3"
SWING OVER TABLE ................................... 5"
CAPACITY BETWEEN CENTERS .......................... 12"
MAXIMUM TABLE TRAVEL .......................... 13-3/4"
TABLE SWIVELS EITHER WAY ................... 10 DEGREES
TABLE TRAVEL PER REV. OF HANDWHEEL .............. 0.44"
HYDRAULIC TABLE TRAVERSE ................ 0 TO 120" IPM
DWELL (CARRIAGE) ....................... 0 TO 8 SECONDS

WHEELHEAD (ALL GRADUATIONS, ON WORK DIAMETER):
TOTAL TRAVEL BY FEED SCREW ................... 3-7/8"
HYDRAULIC RAPID RETRACTION ................... 1-1/8"
INFEED PER REV. OF HANDWHEEL .................. 0.04"
WHEEL FEED GRADUATION ....................... 0.0002"
FINE FEED TO DEAD STOP ..................... 0.00005"
TOTAL PLUNGE INFEED .......................... 0.025"
PLUNGE FEED RATE, MAXIMUM ................ 0.125" IPM
PLUNGE FEED RATE, MINIMUM ............... 0.0025" IPM
INTERMITTENT INFEED, COARSE, MAXIMUM ......... 0.002"
INTERMITTENT INFEED, FINE, MINIMUM ......... 0.00005"
SPARKOUT ............................ 0 TO 50 SECONDS
WHEEL SPEEDS (2) .................... 1830 & 1988 RPM
GRINDING WHEEL .................... 12" X 1-1/2" X 5"
MINIMUM WHEEL DIAMETER FOR ZERO WORK DIAMETER ... 10"

WORKHEAD:
SPINDLE SPEEDS, INFINITELY VARIABLE ... 50 TO 900 RPM
CAPACITY THRU STANDARD DRAW TUBE ............... 3/4"
MAXIMUM COLLET CAPACITY ........................ 3/4"

APPROXIMATE WEIGHT .......................... 2,226 LBS